• Focusing on Logbook, selecting any values to be displayed in the embedded META Viewer, would result in the values of the next column being displayed instead.
  
• In DM Browser, file attachments would be lost upon next iteration/download and while saving a new version of them.
  

• Interface properties assigned to a set in a Connecting Subsystem, but defined in another Subsystem, would not be saved in the Connecting Subsystem file (as undefined).
  
• In addition, through the Solver Job Logs, you can load and compare multiple Logs and can proceed with simultaneous Job monitoring.
  
• Furthermore, definition of Superelements was not handled correctly.
  

• Converting Shells or Faces to Adhesive Faces would lead to an unexpected termination in case of using a Subsystem as "Current" and having active the Subsystem Draw Mode.
  
• Moreover, realizing connections massively would take excessive amount of time on Windows OS
  

• Entities marked as deleted were still considered during application of "Near" function.
  
• New properties would not be visible during creation of Plinks.
  
• Regarding LS-DYNA, unexpected termination would occur when changing the T1 of SECTION_SHELL through Database Browser.
  
• In addition, output of a file with curve IDs above LS-DYNA digit limits would lead to unexpected termination.
  
• Unexpected software abortion would also occur during output of an LS-DYNA file, after compress action.
  
• Focusing on CFD DECKs, certain TAU meshes from legacy meshing tools could not be read in ANSA.
  

• EPILYSIS would terminate if SE data contained undefined DMIG, not used in assembly.
  
• EPILYSIS would spend excessive time (minutes instead of seconds) upon output of the punch file for DMIGPCH Superelements on Windows OS.
  

• Abaqus .odb files were not read properly by "Template Manager" since v25.0.0.
  
• In addition, incorrect reading of template could occur, when "Activate models of active window" was enabled.
  

• Curves were not read properly when multiple groups of channels were defined in the format.
  
• On the other hand, curves from ERFH5 files were read multiple times, when read from session file.
  
• Modal Displacements were not read from SOL111 and SOL112 results file, when the option Modal Displacement (contribution analysis) was selected.
  
• TDMS files were not read correctly either.
  

• Referencing FRF Assembly, Disassembly tool did not work properly since v25.0.0.
  
• Regarding Modal/FRF Correlation, an unexpected termination would occur when loading results from Nastran SOL105 dynamic subcase solution.
  
• Focusing on Modal Response, Element Participations of Grid Point Forces were not calculated in Transient Response.
  
• Plus, there was a slight numerical error in mechanical intensity calculation in Transient Response.
  
• Lastly, incorrect results could occur when using only Structural Damping from Stiffness matrix.
  

• It would not be possible to edit an attached file of a Subsystem.
  
• On the other hand, editing files would copy the edited file in the current working directory, depending on the user's write permissions.
  

• LDAP authentication would not work properly when multiple LDAP domain controllers were defined in the LDAP_URL key of server configuration file (taxis.conf).
  
• Moreover, it would not be possible to set ACLs (privileges) on data based on the value of a particular property/attribute (e.g. Project), in case the list of its accepted values was defined according to rules.
  

• Regarding Strain Life, Endurance limit was taken into consideration.
  
• Plasticity correction was always included in the analysis, even if it was deactivated in analysis configurator.
  

Idézet:A kódrészlet megtekintéséhez be kell jelentkezned, vagy nincs jogosultságod a tartalom megtekintéséhez.