Iceberg Audio SubCut V1.1.1

[Farid-Khan]

File Size: 4.2 MB

Sub Cut lets you apply precise low cuts under 220Hz. Remove unwanted sub bass or make room when layering bass sounds. AUTO mode analyses audio in real-time and continually adjusts the cut by following the notes of your source material. Isolate problematic frequencies in your mix or in your studio. Click on the waveform to quickly flip between your audio and test tones while adjusting your cut.

AUTOMATED CUTS
Automatically adjust your cut
In AUTO mode Sub Cut will analyse the incoming audio and follow the notes of your source material.
Auto mode adjusts the cutoff automatically to maximise the amount of low frequency energy removed.
Choose from Fast, Default and Slow modes to suit your material.

SUB BASS FILTERS
Low frequency only
Sub Cut is different to general purpose EQs. The filters have been fine tuned for 220Hz and below to provide accurate cuts that feel right to musical ears.
Choose from 3 rolloff frequencies. Each has been calibrated to produce a rolloff that is both pleasing and leaves the remaining material clean and uncoloured.
Match the key of your source material. Choose cutoffs by note (e.g. G2) and Sub Cut will only start rolling off below that note.

? What's New
official site does not provide any info about changes in this version.

A kódrészlet megtekintéséhez be kell jelentkezned, vagy nincs jogosultságod a tartalom megtekintéséhez.

⋆?- - - - -☽───⛧ ⤝❖⤞ ⛧───☾ - - - -?⋆

⭐️ Iceberg Audio SubCut V1.1.1 ✅ (4.21 MB)
NitroFlare Link(s) (Premium Link)

A kódrészlet megtekintéséhez be kell jelentkezned, vagy nincs jogosultságod a tartalom megtekintéséhez.

RapidGator Link(s)

A kódrészlet megtekintéséhez be kell jelentkezned, vagy nincs jogosultságod a tartalom megtekintéséhez.